装配式冷库安装的八点注意：

1、阀门使用前应对传动装置进行调试，保持传动装置各项功能完好，极限行程和过力矩保护控制可靠；

2、阀门传动装置各润滑部位调试使用前要充分加润滑油；

3、安装前应将阀门内腔清洗干净，并清除在运输中造成的缺陷；

4、放风阀安装应保持蝶阀传动轴呈水平状态，活塞阀垂直向上的位置。

5、定期加注润滑油，保持各运动部件的良好润滑条件；

6、在使用一段时间后，如发现活塞关闭不严漏风应检查更换活塞环；

7、启动电动装置前，应仔细阅读随机提供的电动装置说明书；

8、阀门使用后要定期观察启闭运行状况，发现问题及时处理。

Eight points to note in assembling cold storage installation: 1. Before using the valve, the transmission device should be debugged to keep the functions of the transmission intact, the limit stroke and over Torque protection control reliable; 2, the valve transmission device lubrication parts before commissioning to fully add oil; 3, before installation should be the valve cavity cleaning, and remove the defects caused in transport; 4, the wind valve should be installed to maintain the butterfly valve drive shaft is horizontal, Piston Valve Vertical upward position. 5. Add Lubricating oil regularly to maintain good lubrication conditions for all moving parts. 6. After using for a period of time, if found that the piston is not closed properly, air leakage should be checked to replace the Piston ring. 7. Before starting the electric device, should carefully read the random electric device instructions; 8, after the use of valves to regularly observe the opening and closing operation, problems found in a timely manner.